Cisco air-lap1142n-a-k9 ios download

So I have been thinking of converting an old N AP to a standalone one just for fun. There are a lot articles from Google giving instructions and I have been struggling following those instructions. Eventually I made it work. So below I will write down the steps that work for me. A switch and two Cat5 cables one to the AP and one to the laptop ;. Steps to follow: 1. Install TftpServer on my Macbook Air; 2. Download the standalone version of the image software ck9w7-tar. Configure the TFTP server in the laptop; 4.

Connect your laptop Ethernet cable to the switch and connect the other cable from your AP Ethernet port to the switch. Power on the switch; 6. Next: 7. Google can help you. You can see now see the Terminal is displaying the AP startup messages.

Keep holding the Mode button until you see the AP showing the red light, then release the Mode button. Usename and password are both Cisco. Next, we will see how to configure your AP so that it can serve the wifi clients. AP conf t Enter configuration commands, one per line. AP config-if encryption vlan 1 mode ciphers tkip aes-ccm AP config-if channel 1 AP config-if antenna gain AP config-if station-role root AP config-if ssid wifi AP config-if-ssid vlan 1 AP config-if-ssid authentication key-management wpa version 2 AP config-if-ssid guest-mode AP config-if-ssid wpa-psk ascii C!

Nice quick guide. Showing results for. Search instead for. Did you mean:. All Community This category This board. Labels: Aironet Access Points. Procedure 1. Download your image from Cisco I chose ck9w7-tar. Hook up your console cable and open up PuTTY 4. Leo Laohoo. VIP Community Legend.

Community Member. Evan, Thank you, worked flawlessly. Thanks Evan, exactly what I was looking for! Latest Contents. Impact of changing power level for AP. Created by zshowip on AM. The APs are about 35FT high at the ceiling.

You will see the message " button is pressed, wait for button to be released Screen capture Output:. IOS Bootloader - Starting system.

Xmodem file system is available. DDR values used from system serial eeprom. PCIE0: link is up. PCIE1: link is up.

PCIEx: initialization done. Reading cookie from system serial eeprom Base Ethernet MAC address: ffa:e4. Version Suffix: k9w Image Name: ck9w7-mx. Version Directory: ck9w7-mx. Ios Image Size: Total Image Size: Image Family: C Wireless Switch Management Version: 8. Extracting files JBB1 bytes Configuring system to use new image Requested system reload in progress JBB1" uncompressed and installed, entry point: 0x Secondary Bootloader - Starting system.

Checking for Over Erased blocks. Restricted Rights Legend.